JSS 1 Fashion Design and Garment Making Flashcards: Cutting, Assembling and Sewing a Simple Garment

Question 1

Before pattern pieces are pinned to Ankara fabric, what must the maker check first?

Accepted Answer

the fabric is prepared and laid flat

Question 2

Why should every pattern piece be included in a trial layout before cutting begins?

Accepted Answer

to confirm they fit and are correctly arranged

Question 3

The arrow printed on a pattern piece is intended to run with the fabric grain. What should the cutter do?

Accepted Answer

align the arrow with the grain direction

Question 4

A pattern shifts whenever scissors reach a corner. What should secure it during cutting?

Accepted Answer

pins or suitable pattern weights

Question 5

When cutting around a pinned pattern, where should the blades travel?

Accepted Answer

along the correct cutting line

Question 6

Two mirrored garment pieces are required from folded fabric. What check prevents two pieces facing the same way?

Accepted Answer

confirm the fold and pattern orientation before cutting

Question 7

After cutting, why should each fabric piece remain identifiable?

Accepted Answer

front, back and other parts must be assembled correctly

Question 8

What temporary action can hold a side seam for checking before permanent machine stitching?

Accepted Answer

pin or tack it

Question 9

The two side-seam edges meet at the waist but one extends 4 cm beyond the other at the hem. What should happen next?

Accepted Answer

check the pieces and matching points before sewing

Question 10

In what order should a basic garment normally move through these stages: cut, assemble, fit-check, finish edges, press?

Accepted Answer

cut, assemble, fit-check, finish edges, press

Question 11

A seam puckers after machine stitching. What should be checked before sewing the next seam?

Accepted Answer

thread tension, stitch setting and fabric handling

Question 12

The stitching line is secure, but the raw allowance sheds threads inside the garment. What step is still needed?

Accepted Answer

finish the raw seam edge

Question 13

At a fitting, the simple top restricts the wearer's arm movement. What is the responsible response?

Accepted Answer

mark and correct the fit before final finishing

Question 14

Why should a seam be pressed during construction rather than only at the end?

Accepted Answer

pressing helps each section lie correctly for the next step

Question 15

A contrasting thread is chosen for visible topstitching. What must the maker ensure?

Accepted Answer

the stitching is even because it will be noticeable

Question 16

The machine needle breaks while joining thick layers. What is the first safe action?

Accepted Answer

stop the machine and switch off the power

Question 17

Complete the quality check before display: trim loose threads, inspect seams, press the garment and _____.

Accepted Answer

check its overall fit and finish

Question 18

Why is modelling a finished garment useful during assessment?

Accepted Answer

it shows fit, movement and overall appearance

Question 19

A learner describes the finished apron only as “nice.” What would make the discussion more useful?

Accepted Answer

comment on fit, seams, edge finishes and pressing

Question 20

Which complete workflow is sound: check pattern, lay and cut, assemble, fit, finish, press and present; or cut randomly, sew, then measure?

Accepted Answer

check pattern, lay and cut, assemble, fit, finish, press and present

Strong work.